I heard that many people will feel confused and stressed about subject 3?
Next, I will reveal the process of technical knowledge points in the third subject of the driving test.
Hurry up and bookmark it.
1. Go around the car.
Go around the car counterclockwise, get on and off the car, and pay attention to the left and right conditions.
2. Get on the bus and prepare.
Get in the car, close the doors tightly, and check from left to right:
Check whether the headlight switch is off first.
Check the dashboard engine tachometer to confirm that the engine is in working condition.
Confirm neutral gear and pull up the handbrake.
Fasten your seatbelt after adjusting your seat.
After all items are checked, if the vehicle is in the flame-off state, the key must be screwed to the end, and the engine tachometer pointer is completely cocked and then let go to prevent the computer from broadcasting the second ignition.
If the vehicle is in the starting state, leave it alone.
3. Night light simulation.
Follow the voice prompts.
Fourth, get started. One turns, two whistles, three observes, four hangs one gear, five puts the handbrake, and six starts.
After starting, you can't drive more than 50 meters in the first gear (the first gear can't exceed 50 meters in any section) Hurry up and change to the second gear.
5. Drive in a straight line.
Drive straight and look ahead, the speed is controlled at about 20km h, the steering wheel can not shake significantly, but it cannot move in any direction, and in the process of driving forward, you can not deviate from the original track by 30cm to the left and right. Go straight for 100 meters to finish.
6. Turn left or right ahead.
When you hear the voice announcement, you can turn on the turn signal or turn on the turn signal before the double solid line. Brake at the first guide arrow before the stop line, and the speed of the vehicle should not be lower than 20km h when braking, and observe left and right. Turn left into the target lane and turn off your turn signal. Turn right into the target lane and turn off the turn signal.
7. Go straight ahead and pass through the intersection.
After hearing the voice announcement, the speed of the vehicle drops to about 20 km h, and the brake is clicked, and the left and right observations are observed.
8. Meeting. After hearing the voice announcement, it began to slow down and maintain a speed of 30 km/h
9. Change lanes.
Turn on the turn signal after hearing the lane change prompt, (note that you can change lanes left or right, don't hit the wrong turn signal) The turn signal flashes enough for 3 seconds to change lanes. After changing lanes, drive for more than 5 seconds, turn on the turn signal and flash for 3 seconds, and look at the rearview mirrors on both sides to confirm that it is safe to return to the original lane.
10. Overtaking. Turn on the left turn signal after hearing the overtaking prompt, the turn signal flashes for 3 seconds, look at the left and right rearview mirrors to ensure safe lane change, turn off the turn signal after changing lanes, and the overtaking is completed.
Ten. 1. Pedestrian crossings.
There is no voice announcement at the crosswalk, you need to be familiar with the route one day in advance, and the front of the car is covered by the diamond-shaped block before the horizontal line and the brakes are pressed, and the left and right observations (the amplitude of left and right observation can be larger).
Ten. Second, the school section.
There are no voice prompts for school locations, but there are street signs.
When you see the location of the school, reduce the speed to 20km h in advance, brake, and observe left and right, (the amplitude of left and right observation can be larger).
Ten. 3. Bus stops.
There are no voice prompts, but there are street signs.
When you see the bus stop, reduce the speed to 20km h in advance, brake, and observe left and right, (the amplitude of left and right observation can be a little larger).
Ten. Fourth, make a U-turn.
Turn on the left turn signal after hearing the U-turn prompt, slow down and downshift, and do not press the zebra crossing to make a U-turn. After the U-turn is completed, you should quickly refuel and increase the gear, and you should not continue to drive at low speed.
Ten. Fifth, add or subtract gears.
The speed of the vehicle is 25 km h in third gear, and the third gear is accelerated to 35 km h in fourth gear for more than 6 seconds.
Don't step on the clutch, decelerate and downshift after 6 seconds, reduce the fourth gear to 30km h and hang the third gear, and reduce the third gear to 20km h to change the second gear. (Remember not to look down at the gear).
Ten. 6. Pull over.
After hearing the voice command, turn on the right-facing light, observe the rearview mirror left and right, and stop in the direction of the right side after 3 seconds. Turn off your turn signals when parked. (The distance between the body and the sideline cannot exceed 30cm).
Driving Test Module 3 is a test that requires skill and experience.
But as long as you have the right knowledge points and processes.
I believe that everyone can handle it easily.
Hopefully, the above tips will be helpful to you.
Here's wishing you all a smooth pass of the exam.
Get your driver's license early.