In the process of drying slime, the coal injector is mainly used as a heat source equipment, and its use method is as follows:
Turn on the main engine motor to make the cylinder start to rotate, which is the first step in drying the slime.
The burner ignites and the injector starts working. At this time, the pulverized coal is burned in the combustion furnace to produce a large amount of hot gas.
After about five minutes, start adding the slime. After that, the equipment basically runs automatically, and the operator only needs to observe whether each equipment is operating normally.
After the complete set of equipment is successfully started, the operator needs to move to the discharge port to check whether the moisture content of the dried slime meets the requirements. If the requirements are not met, the operating parameters of the equipment should be adjusted in time to make the moisture content of the slime reach the standard.
After ensuring that the moisture content of the slime meets the standard, the feed volume can be increased, and the operation of the equipment can be adjusted while increasing, so that the output of the equipment can reach the expected standard.
Please note that the above steps are general operating guidelines, and the specific operation steps may vary depending on the equipment model, the nature of the slime, and other factors. Therefore, in actual operation, you should refer to the operation manual and adjust it according to the actual situation. At the same time, in order to ensure the safety and efficiency of the operation, the operator should receive relevant training and have the corresponding operating experience.