Mobile phone film is a technical job that requires a certain amount of skill and patience. Below we will introduce in detail the steps of how to apply the film to your phone to help you complete the film work easily.
1. Preparations.
Before we start applying the film, we need to do a lot of preparation. First of all, we need to prepare a suitable film for our mobile phone to ensure that the quality and size of the film meet the requirements. At the same time, we also need to prepare some necessary tools, such as: cleaning cloth, dust removal sticker, scratch card, etc.
2. Clean the screen.
Before applying the film, we need to clean the phone screen thoroughly. Use a cleaning cloth dipped in an appropriate amount of detergent and gently wipe the phone screen, being careful not to use an overly wet cloth to avoid leaving water stains on the phone screen. After wiping it off, use a dust strip to thoroughly remove any residue and fingerprints from the screen.
3. Align the film.
Gently unfold the film and place it on the phone screen, making sure that the film is in the correct position and orientation. If the film has a marking line, you need to align the marking line with the edge of the phone screen. If there is no marking line, you need to pay attention to the edge of the film that coincides with the edge of the phone screen.
Fourth, apply pressure.
After aligning the film, we need to use a scratch card to slowly apply pressure, starting from the corner of the phone screen and slowly pushing the film, gradually covering the entire screen. During the process of applying pressure, care needs to be taken not to allow air or debris to get between the film and the screen, which may cause bubbles or residue.
5. Check and adjust.
After the film is finished, we need to check that the film is completely attached to the phone screen, if there are air bubbles or residues, you can use a scratch card to slowly remove them. If the position and orientation of the film is incorrect, the position and orientation of the film need to be readjusted.
6. Wait for drying.
Finally, we need to wait for a while for the film to dry naturally. During this period, do not expose your phone to the sun or use a hot object to heat the film, so as not to cause the film to deform or fall off. Usually wait 2-3 hours for the film to dry completely and fix on the phone screen.
The above are the detailed steps to apply the film to the phone. It is important to note that laminating is a technical job that requires patience and care, and it needs to be done according to the correct steps to avoid unnecessary loss or waste. At the same time, it is also very important to choose a suitable size film. Hope this article was helpful to you.