1. Prepare tools and materials.
Before proceeding with the installation of tap hot melt water pipes, the following tools and materials need to be prepared:
1.Hot dissolved water pipe: Select the appropriate specification of hot dissolved water pipe according to your needs, and pay attention to the pipe diameter, length, quality and other parameters.
2.Scissors: Used to cut hot dissolved water pipes.
3.Melter: It is used to heat the hot melt water pipe and connect it to it.
4.Water Pipe Joint: It is used to connect hot water pipes with other water pipes or equipment.
5.Water pipe screws and washers: used to secure water pipe joints.
6.Water pipe clamp: used to fix the water pipe and prevent shaking.
7.Adhesive tape: used to seal the connection and prevent water leakage.
Second, the installation steps.
1.Determine the installation location: Determine the installation location of the tap hot water pipe as needed, and ensure that the installation location is flat, dry, and free of flammable materials.
2.Cut the hot water pipe: Use scissors to cut the hot water pipe to a suitable length, taking care that the pipe diameter matches the connected water pipe joint.
3.Clean the fittings: Use a clean rag or paper towel to wipe the water pipe fittings clean and make sure there are no dust or impurities.
4.Heating the hot melt water tube: Plug the hot melter into the electricity and heat the hot melt water tube until the tube becomes soft. Note that the heating time should not be too long, so as not to make the tube too soft or melt.
5.Connect the water pipe joint: Insert the cut hot melt water pipe into the water pipe joint, making sure that the connection is tight and there are no gaps. Then use the hose screws and washers to secure the joint.
6.Check for water leakage: After the installation is complete, check the connections for water leakage. You can gently press on the water pipe fitting to see if there is any water seeping out. If there is a water leak, reinstall the fitting or replace the water pipe.
7.Fix the water pipe: Use the water pipe clip to fix the connected water pipe to the wall to prevent the water pipe from shaking or falling off. At the same time, the connection can be sealed with adhesive tape to enhance the seal and prevent water leakage.
8.Test the water flow: Turn on the water source and test whether the installation of the hot water pipe is successful. Observe whether the water flow is smooth and whether there is any leakage. If there is any abnormal situation, please deal with it in time.
3. Precautions.
1.During the installation process, keep your hands clean to avoid impurities such as oil and dust affecting the connection effect.
2.After the installation is completed, it is necessary to regularly check whether the connection of the tap hot water pipe is firm and whether there is any water leakage. If problems are found, deal with them in a timely manner.
3.During use, do not pull or twist the tap hot water hose to avoid damage or leakage.
4.When not using the tap hot dissolved water pipe, the water source should be turned off to avoid unnecessary waste or damage caused by long-term running water.