Because the splicing of the bolt frame beam mold has been completed, its volume is large, so the method of on-site pouring can only be adopted. After the bolt frame beam formwork is assembled, the release agent is sprayed on the inner wall of the mold, and then the concrete is injected from different directions until there are no gaps before vibrating.
Because there is a risk of rockfall or small landslides on the road near the foot of the mountain, this can lead to traffic accidents and traffic congestion, thus better increasing the traffic safety accident hazard. The anchor frame beams made of arched slope protection molds can be placed on the surface of the mountain, and the middle and both sides are backfilled with soil to prevent the loosening of the surface soil. In addition, some trees can be planted around to strengthen the soil and avoid soil erosion. The square slope protection brick mold can be used again, and the size of the finished product meets the process requirements.
There are many different sizes of cast-in-place frame formwork, so without a description of the specific size, it is impossible to determine which specification of ramp is used. However, with drawings as a basis for production, details can be handled more accurately during the production process.