Before learning how to use the tile joint applicator, you first need to have an overall understanding of the tile caulking glue gun and make some preparations.
Check the tool: Make sure that the appearance of the tile joint glue gun is in good condition, among which problems such as jammed cam wires and loose glue gun chucks need to be dealt with in time. In addition, check whether the barrel is smooth to ensure smooth subsequent construction.
2.Check the pressure: Confirm that the pressure of the sewing applicator is sufficient. In general, the pressure of the applicator should be 04-0.8MPa, if necessary, it can be adjusted according to the actual use requirements.
3.Prepare the sewing adhesive: according to the material and color of the tile, choose the appropriate sewing adhesive. Ensure that the adhesive is compatible with the surface of the tile, and has excellent durability and waterproof properties.
Before construction, the surface of the tile should first be cleaned to ensure the effect of one-piece seam. Use a detergent and brush to remove all stains, dust, and grease and rinse off with water.
Assemble the barrel of the glue gun tightly with the tip, and make sure that the connection between the chuck and the barrel is firm and reliable.
Fill the quilt into the bucket of the applicator, taking care to avoid air bubbles. Be careful not to pour in too much glue to avoid waste.
Aim the tip of the sewing gun at the gap in the tile and slowly squeeze the handle so that the glue is evenly spread in the gap. Use a spatula to scrape the excess sewing adhesive flat. In this process, the right amount of water and a wet sponge can be used to achieve better results.
The strength of the squeezing handle needs to be moderate, too strong may cause the flow of the sewing glue to be too large, and too light will be difficult to fill the sewing glue into the gap, so it requires the accumulation of experience and skills.
In the construction process, the hand speed is too fast or too slow, which will affect the uniformity of the distribution of the sewing glue, so the construction should be maintained at a uniform speed, especially for long-term operations.
When using a scraper to smooth out excess seam glue, pay attention to the angle of the scraper to avoid scratching the surface of the tile. At the same time, the use of wet sponge can effectively erase the excess beauty glue and improve the aesthetic effect of construction.
Ceramic tile joint glue gun is a professional construction tool, and mastering its use has an important impact on the completion of ceramic tile joint project. Through the detailed introduction of the preparation work, the construction steps and the sharing of use skills, we hope to help readers make better use of the tile joint gun to complete a higher quality ceramic tile joint project.