Uniview EzWall adds third-party device (DH) configuration guide.
1. Function introduction.
Uniview EZWaw adds common configuration for third-party devices (DH). (Applicable to our decoder on site.) ）
2. Configuration steps.
Ensure that the network between the camera and the PC is interconnected.
Enter the camera username, password, and corresponding code correctly.
Open the ezwall, login diagram (1) windowThe current device addressSet the address of the connection decoder, enter the account and password of the decoder with the username and password, and display Figure (2) after logging in. 
Figure (1).
Figure (2) Device Management --> Add --> Device Information: Figure (3) Add DH Device ONVIF Protocol: IP, Port 80, User Name, Password, Enter and click OK
Figure (3) GB protocol to add device: login figure (4) Decoder, system configuration --> operation mode --> GB local settings: set SIP server encoding, 11-13 bit encoding is 114, SIP server port 5063, the information needs to be added to the camera. 
Figure (4) Login to DH camera figure (5): Settings--> platform access-->GB 28181, [GB 28181] access checked, SIP server number: SIP server encoding ---34020000001140000001 of the decoder;
SIP Server IP: The IP --- of the decoder is 192168.100.14;
SIP Server Port: The SIP server port of the decoder --- 5063;
Device code number: Set a non-conflicting national standard code for the camera in this network, 11-13 bits 131 or 132
Registration Password: Set a national standard authentication password.
Channel ID: This is the same as the device code, and the device code is entered in the EZWALL.
Figure (5) Equipment infographic (6): GB28181 is selected as protocol, the device code is consistent with the channel number on the camera side, the user name is filled in with the camera user name, and the password is entered into the national standard authentication password. 
Figure (6) RTSP protocol to add a device: device infographic (7): RTSP is selected as protocol, Dahua is selected as custom protocol, and the camera username and password are filled in for the user name
Figure (7)3, after the device management is added to Figure (8), you can see the corresponding protocol added by the online device.
Figure (8) 3. Configure key points.
1. To add the onvif protocol mode, make sure that the camera is enabled onvif.
2. The national standard protocol is added, and the national standard code of the decoder needs to be added to the national standard code on the camera side;
Ezwall, add the GB channel code on the camera.
3. The RTSP protocol is added, and the corresponding manufacturer is selected for the custom protocol.