EzTools batch debugging EI-371 third-generation indoor station deployment guidance
eztools 3.0 is a LAN device management tool, which is mainly used to manage and configure IPC, NVR, display and control equipment, indoor unit and access control (door machine) and other equipment. The current version supports batch configuration of the IP address and room number of the indoor unit, which is convenient for the use of large-scale indoor unit networks on site.
In this issue, let's learn how to use EZTOOLS to debug the EI-371 indoor station in batches.
**、Install eztools software**、Install the batch configuration tool of eztools indoor computer (version number: eztools-r1122.).3.0.0.l04.230811）。
**, fill in the templateOpen the eztools tool, and in the device management interface, click Building Configuration - ** Template.
The main interface of the man-machine.
According to the template, plan the location information of the VTO and VTO in advance, and assign IP addresses. Device type, network information is required (IP, subnet mask, gateway), if it is an indoor unit, you can enter the building, unit, room, if it is a unit door station, door station, you can enter the building, unit, extension number (the extension number only needs to be configured for the door machine), and click Save after filling in.
Fill in the template. 
Search for Add DeviceAfter powering on the indoor station and the VTO station, connect them to the same network segment, open the eztools tool, and click Search to add them on the device management page.
Search for adds. 
On the device management interface, click Search to add, check multiple devices that need to be modified, click Modify Network Parameters, enter the starting IP and password (if the password has not been modified, the initial password of the VTO needs to be entered admin, and the initial password of the indoor station needs to be entered 123456), and finally click OK.
Bulk editing. 
On the device management page, click Search to add, select the devices to be added, click the "+" sign or "Add in batches", and enter the device password (if the device has not changed the password, the initial password is 123456; If you have changed your password, enter the changed password), and finally click OK.
Bulk editing. 
On the Device Management page, click Building Configuration - Import. After the import is successful, the operation status changes to Relationship Configuration.
Import the template. 
The import was successful. 
DoneFinally, according to the pre-planned template, search for the location information in ** according to the IP address, and write the corresponding location information on the device package; After the indoor unit completes the above operations, power off the device and put it into the corresponding original packaging; After the VTO is bound to all the indoor units in the building, power off the device, write the corresponding location information on the equipment package, and then put it into the original package.
After all the equipment is configured, the installer can install the equipment to the specified location according to the location information.
thanks
end-