Elevator shaft wall
Procedure
On the tab, select [Dawn BIM Modeling] - sporadic components, and select the [Elevator Shaft Wall] function;
Create a new type and select Manual Layout or Room Layout.
Note: Before arranging, the components need to be classified as concrete walls in advance, otherwise they will not be generated normally.
2-1 Layout results.
Here is an example of setting up a room:
2-2 Arrange the elevator shaft wall (front).
2-3 Arrange the elevator shaft wall (back).
After the layout is completed, some friends will ask: how to choose the elevator shaft wall, there is no engineering quantity, is blank?
2-4 Elevator shaft wall engineering quantity.
If you need to view the engineering quantity, select the concrete wall, and the calculation project will display the project name: [Elevator shaft wall area].
2-5 Elevator shaft wall engineering quantity (area).
By selecting the attached concrete wall to view the engineering quantity, it will be found that the elevator shaft wall is calculated as the area, and how to calculate the ultra-high engineering quantity of the formwork? Do you need to lay out the entities, or can the software calculate it directly?
You can first find the calculation rules of the concrete wall through the [Calculation Settings] function under the Chenxi BIM civil engineering module, and you will find that there is a calculation of the over-height area of the elevator shaft wall template, which needs to be added to the project output column, that is, the engineering quantity output column will be displayed.
2-6 Calculation rules.
2-7 project outputs.
2-8 elevator shaft wall formwork super high area.
Frequently Asked Questions
If I accidentally click on the batch layout again, will the amount of work increase due to repeated layout?
Reply: The repeated arrangement software will automatically make a judgment, and there will be a layout result prompt box: prompt the repeated arrangement of components, and there will be no increase in the amount of work.
2-9 Layout results.
Can the bottom height be adjusted artificially? The bottom height of the elevator shaft wall needs to be offset downward by 50.
Re: Select the property in the function interface to set the bottom height, and the bottom of the generated entity will be offset. (+ is positive, - is negative).
2-10 elevator shaft wall attributes.