The steps of AW pneumatic actuator disassembly and assembly are as follows: AW pneumatic actuator 1. Preparation Before disassembling and assembling AW pneumatic actuator, the following preparations need to be carried out: 1Prepare the required tools and materials, including screwdrivers, wrenches, feeler gauges, etc.;2.Read the installation and use instructions of AW pneumatic actuators carefully to understand the methods and precautions for disassembly and assembly3.Confirm the model and specification of the AW pneumatic actuator and ensure that the correct tools and materials are selected4.Ensure that the work site is safe and tidy, and take protective measures.
Second, disassembly and assembly steps
The following describes the disassembly and assembly steps of AW pneumatic actuators:
1.Turn off the air source: Before disassembling and assembling the AW pneumatic actuator, you need to turn off the air source to ensure that the air source has stopped**;
2.Loosen the set screws: Use a screwdriver to loosen the set screws on the AW pneumatic actuator housing, generally there are 4 screws that need to be loosened;
3.Remove the actuator: When the set screw is loosened, remove the actuator from the pipe;
4.Disassembling the cylinder: Use a wrench to remove the cylinder from the actuator;
5.Clean the parts: Use the feeler gauge to clean the impurities inside the cylinder to ensure that the inside of the cylinder is clean and free of foreign objects
6.Check the parts: check the cylinder, piston and other parts for wear or damage, if necessary, you can replace the new parts;
7.Assembling the actuator: Assemble the cylinder, piston and other parts in the order on the manual and install them on the pipe;
8.Debugging the actuator: Turn on the air source, debug whether the switch and action of the AW pneumatic actuator are normal, and adjust if there is a problem
9.Complete the installation: After the debugging is confirmed, the disassembly and assembly of the AW pneumatic actuator can be completed.
3. Precautions
When disassembling and assembling AW pneumatic actuators, the following matters need to be noted:
1.In the process of disassembly and assembly, it needs to be handled with care to avoid damage to parts or personal injury;
2.When using tools such as wrenches, it is necessary to choose the appropriate specifications and ensure that the force is evenly used to avoid damage to the parts due to excessive force
3.When cleaning parts, it is necessary to use clean cloth and feeler gauge and other tools to avoid secondary pollution caused by unclean cloth or tools;
4.During the installation process, it is necessary to ensure that the components are installed correctly to avoid the unsmooth or damaged actuator caused by incorrect installation
5.During the debugging process, it is necessary to observe whether the switch and action of the actuator are normal, and if there is any problem, it needs to be adjusted and repaired in time.
4. Common problems and solutions
When disassembling and assembling AW pneumatic actuators, some common problems may be encountered and the solutions are as follows:
1.The actuator cannot operate or the action is not smooth: it may be caused by insufficient air source** or pipeline leakage, etc., and it is necessary to check the condition of the air source** and whether the pipeline connection is well sealed
2.The actuator switch is not sensitive: it may be caused by impurities or dust inside the switch, etc., and it is necessary to clean up the impurities and dust inside the switch
3.Oil leakage in the actuator: It may be caused by damage or improper installation of the oil seal, etc., and the oil seal needs to be replaced or reinstalled
4.Excessive actuator noise: It may be caused by worn or loose parts, etc., and it is necessary to check whether the connection of each component is firm and wearable.