When the ceramic filter has the problem of not absorbing ore, you can try the following solutions:
Check the filter plate and filter cloth:
Regularly check the status of the filter plate and filter cloth, replace it in time if damaged, and ensure that the filter cloth and the filter plate fit tightly to avoid blockage of the filter holes.
Adjust the operating parameters:
Adjust the operating parameters according to the actual situation, such as reducing the feeding speed, ensuring the uniformity of the feeding, adjusting the vacuum level, etc., to improve the ore absorption efficiency.
Clean the equipment regularly:
The ceramic filter is cleaned regularly to remove surface blockages, and the equipment can be thoroughly cleaned by pickling and other methods to ensure its normal operation.
Strengthen equipment maintenance:
Establish an equipment maintenance system, regular inspection and maintenance, such as cleaning sediments, regularly replacing filter cloths, etc., to maintain a good ore absorption effect.
Check the vacuum system:
If there is a vacuum problem, the vacuum pump and its tubing should be checked for faults or air leaks, as well as the working condition of components such as the dispensing head and ceramic plate.
Check the feeding conditions:
Confirm whether there are changes in factors such as the type of slurry, slurry content, fineness and concentration, which may affect the absorption effect.
Joint Cleaning:
In some cases, combined cleaning can help restore the suction effect, but be aware that the suction capacity may be better in the initial time after cleaning, and then gradually decrease.
Adjust the characteristics of the feed liquid:
Select the appropriate pore size of the filter plate according to the diameter of the particles to be separated; The viscosity of the feed liquid is reduced by adding solvents or diluents to suit ceramic filters.
Pretreatment Liquid:
Pretreatment is performed before the feed enters the ceramic filter to remove impurities, which helps to improve ore absorption.